Drill throught breaking co-display
15 November, 2011
Hi,
Have created a report A which I have co-displayed with reports B, C so that when going into report A you see reports B, C on additional tabs.
In addition to the above report B drills through to report C (field on B connecting to filter on C).
When entering report A I can look at the the 3 co-displayed reports without any problems. When I click on the drill through field on report B the report exits to the main Report List.
regards
Robin
Have created a report A which I have co-displayed with reports B, C so that when going into report A you see reports B, C on additional tabs.
In addition to the above report B drills through to report C (field on B connecting to filter on C).
When entering report A I can look at the the 3 co-displayed reports without any problems. When I click on the drill through field on report B the report exits to the main Report List.
regards
Robin
Hi Robin,
Apologies for the delayed response.
This generally occurs when the report cannot find the report to drill to.
Eg.. the report has been marked as 'draft' or is deleted.
Can you please double-check the drill configuration and make sure report C does not had added security applied.
If you believe everything is configured correctly, can you please email screenshots of Report B , Report C and the drill configuration to support@yellowfin.com.au
Thanks,
David
Apologies for the delayed response.
This generally occurs when the report cannot find the report to drill to.
Eg.. the report has been marked as 'draft' or is deleted.
Can you please double-check the drill configuration and make sure report C does not had added security applied.
If you believe everything is configured correctly, can you please email screenshots of Report B , Report C and the drill configuration to support@yellowfin.com.au
Thanks,
David
Thanks David,
Tested again after checking as suggested and working as expected - believe it is because the report was in draft that I had the problem.
regards
Robin
Tested again after checking as suggested and working as expected - believe it is because the report was in draft that I had the problem.
regards
Robin